Sending Scan Files by Scan to Folder
66
2
I Check the test result, and then press [Exit].
J Press the {OK} key.
Note
❒ If you change the protocol after entering the path name, user name, or
password, a confirmation message appears.
❒ You can connect only to folders that you have the read privileges for.
❒ The connection test may take time.
❒ Even if the connection test was successful, the machine may fail to transfer
the file if you do not have write privileges for the file or there is not enough
free hard disk space.
❒ You can register the destination path in the machine’s address book. For
details, see “Registering the Path to the Selected Destination in the Address
Book”.
Reference
p.69 “Registering the Path to the Selected Destination in the Address
Book”
To Next Page
Loading...
