Items for Specifying Scan Settings
107
6
Setting procedure of custom size when scanning part of an original
This section explains how to set a custom size for scanning an area within an
original.
To scan a section of an original, measure Original Size (X1 and Y1), Start Position
(X2 and Y2), and Scan Area (X3 and Y3) on the surface of the original, and then
enter those values in the same order. Measuring methods differ depending on
the original’s orientation and the position it is set in. Examples 1 to 3 below show
how to measure the size in order to scan the section marked “R”. Refer to the fol-
lowing examples to measure each size correctly.
❖ Example 1
❖ Example 2
Original is placed in the
orientation on the expo-
sure glass or in the ADF
Original is placed in the
orientation on the expo-
sure glass
ARE014S
ARE015S
To Next Page
Loading...
