Scan Settings
203
6
Scan Settings
This section describes the user tools in the Scan Settings menu under Scanner
Features.
Default settings are shown in bold type.
❖ A.C.S. Sensitivity Level
Sets the sensitivity level for judging colour/black and white for scanning
originals when [Scan Type] is set to [Auto Colour Select].
❖ Wait Time for Next Orig.: Exposure Glass
To divide originals and scanning them individually with the exposure glass
to form a single file, select [Continuous Wait], [Off], or [Set Wait Time] for the wait-
ing status.
•Continuous Wait
•Off
• Set Wait Time: 60 sec.
If you select [SADF] in [Original Feed Type] on the Scan to Folder screen, the [Wait
Time for Next Orig.: Exposure Glass] setting becomes invalid.
If you select [Batch] in [Original Feed Type] on the Scan to Folder screen, the
[Wait Time for Next Orig.: Exposure Glass] setting becomes invalid, and the ma-
chine waits for an additional original to be placed.
If [Set Wait Time] is selected, enter the wait time in seconds (3-999) for placing
additional originals with the number keys. Scanning will start if additional
originals are placed and the {Start} key is pressed within this time. You can
end scanning and begin transmission by pressing the {q} key within this
time. Once the specified time has elapsed, transmission starts automatically.
If [Continuous Wait] is selected, the machine will wait for additional originals
until the {q} key is pressed. Scanning will start when additional originals
are placed and the {Start} key is pressed. You can end scanning and begin
sending by pressing the {q} key.
If originals are placed in the ADF (auto document feeder), transmission will
start without waiting for additional originals after all originals in the ADF
have been scanned, regardless of the specified settings.
If a paper misfeed occurs or any of the following operations are performed
while the machine is waiting for additional originals, the countdown stops
and does not start again until the {q} key is pressed.
• Changing the settings such as the scan settings
• Opening the upper cover of the ADF
•Pressing the {Interrupt} key to activate the copy mode
To Next Page
Loading...
Need help?
General
