Assigning the machine's IPv6 address manually
• The IPv6 address assigned to the machine must not be used by any other device on the same
network.
• Make sure [DHCPv6] is set to [Disable] in [IPv6] in Web Image Monitor. For information about
how to launch Web Image Monitor, see page 129 "Using Web Image Monitor".
1. Press the [User Tools] key.
2. Press the [ ] or [ ] key to select [Network Settings], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Machine IPv6 Address], and then press the [OK] key.
4. Press the [ ] or [ ] key to select [Use IPv6], and then press the [OK] key.
5. Press the [ ] or [ ] key to select [On], and then press the [OK] key.
If this setting is changed, the machine will reboot automatically before the procedure is complete.
When this happens, wait for the reboot to finish, repeat Steps 1 to 3, and then proceed to the next
step.
6. Press the [ ] or [ ] key to select [Manual Config. Add.], and then press the [OK] key.
7. Press the [ ] or [ ] key to select [IP Address], and then press the [OK] key.
8. Enter the machine’s IPv6 address using the number keys.
9. Enter the values in all fields, and then press the [OK] key.
If this setting is changed, the machine will reboot automatically before the procedure is complete.
When this happens, wait for the reboot to finish, repeat Steps 1 to 3, and then proceed to the next
step.
10. Press the [ ] or [ ] key to select [Prefix Length], and then press the [OK] key.
11. Enter the prefix length using the number keys, and then press the [OK] key.
After a setting is changed, the machine automatically reboots itself.
1. Guide to the Machine
22
To Next Page
Loading...
