Paper and Other Media
27
To select custom size paper (5.83 - 35.43 inch in length, 2.76 - 8.50 inch in
width), see p.27 “
Specifying custom size paper for the Bypass Tray”.
For control panel settings when using thick paper, OHP transparencies, or
post cards, see p.28 “
Specifying a paper type for the Bypass Tray”.
Specifying custom size paper for the Bypass Tray
❒ When loading custom size or special paper, specify the paper size using the
control panel and printer driver.
❒ Paper sizes between 5.83 - 35.43 inch in length and 2.76 - 8.50 inch in width
can be loaded in the bypass tray. However, the printer can be set to print on
paper up to 26.77 inch in length when using RPCS for the printer driver, 26.65
inch when using PS3, and 17.00 inch when using PCL.
❒ The custom paper size selected using the printer driver overrides that select-
ed using the control panel. Do not configure settings using the control panel if
you have already made settings using the printer driver. However, when print-
ing with a printer driver other than the RPCS printer driver, you must configure
the settings using control panel.
❒ You cannot print on custom size paper with an application that does not sup-
port the custom size setting.
A Press the {Menu} key.
“Menu” appears on the display.
B Press the {U} or {T} key to display “Paper Input”, and then press the {#
Enter} key.
The paper selection menu appears.
C Check “Bypass Size” appears, and then press the {# Enter} key
The paper size selection menu appears.
Menu:
Paper Input
To Next Page
Loading...
Need help?
General
