EasyManua.ls Logo

Ricoh CX3 - M-Cont Plus (10 M)

Ricoh CX3
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
59
3
Shooting Mode Types
Note -------------------------------------------------------------------------------------
The flash cannot be used.
The camera shake correction function cannot be used. If you set the mode dial
to R while the camera shake correction function is enabled, E disappears
from the picture display.
Focus, exposure value, and white balance are locked.
ISO sensitivity is raised.
Flickering may be recorded as horizontal bands when pictures are taken under
fluorescent lights.
When [Card Sequence No.] is set to [On] (GP.96) and the last four digits of
the file number exceed “9999” during continuous shooting, a separate folder
is created in the SD memory card and successive pictures taken in continuous
mode are stored in this folder.
MP file ----------------------------------------------------------------------------------
MP is a file format for recording a set of still images.
M-Cont Plus (10M)
In this mode, the camera shoots while the shutter-release button is
pressed, but only the last 15 frames (about the last three seconds of
shooting) are recorded to create a single multi-picture (MP) file.
When you remove your finger
from the shutter release button...
…the camera records the 15 frames taken
in the last 3 s of shooting.
Caution ---------------------------------------------------------------------------------
The time needed to record 15 frames may increase if lighting is poor.
Note -------------------------------------------------------------------------------------
The image size is fixed at 4 : 3 N.
The date and orientation of each shot in the sequence are recorded separately.

Table of Contents

Other manuals for Ricoh CX3

Related product manuals