Other Printing Problems
49
3
Duplex printing is
malfunctioning.
Duplex printing can-
not be done with paper
set in the bypass tray.
When using duplex printing, make settings to
use paper from a tray other than the bypass
tray.
Duplex printing is
malfunctioning.
The upper tray cannot
be used as an output
destination in duplex
mode.
Specify a another output tray.
Duplex printing is
malfunctioning.
Duplex printing can-
not be done with a tray
for which [1 Sided Copy]
has been specified as
Paper Type on the Sys-
tem Settings menu.
Change the Paper Type setting for the tray to
[2 Sided Copy] on the System Settings menu.
See “System Settings”, General Settings
Guide.
When using Windows
95 / 98 / Me / 2000 /
XP, Windows Server
2003, or Windows NT
4.0, combined printing
or booklet printing
does not come out as
expected.
The correct applica-
tion or printer driver
settings are not made.
Make sure the application's paper size and ori-
entation settings match those of the printer
driver. If a different paper size and orientation
are set, select the same size and orientation.
A print instruction
was issued from the
computer, but print-
ing did not start.
User Authentication
may have been set.
Contact the administrators.
No transmission
when using 1394 in-
terface connection.
• Interface connec-
tion has not been
made.
• The correct com-
puter settings are
not made.
Check using the following procedure:
A Confirm the IEEE 1394 interface cable is
connected securely.
B Restart the computer. If the error occurs
even after executing the above operation,
proceed to the following steps.
C Unplug the IEEE 1394 interface cable con-
nected to the computer.
D Run the utility tool for the IEEE 1394 inter-
face board, which is stored in the following
path on the CD-ROM “Printer Drivers and
Utilities”:
\UTILITY\1394\
(For more information about using the util-
ity tool for IEEE 1394, see the README file
in the same directory on the CD-ROM.)
E Restart the computer.
Problem Cause Solution
To Next Page
Loading...
