Name: Enter a registration name. The name is to distinguish the server from another LDAP server.
Server Name: Enter the host name or IPv4 address of the LDAP server.
Search Base: Select a root folder to start a search. E-mail addresses stored in this folder are search targets
when files are sent using the Scanner or Fax function.
Port Number: Enter the port number used for the communication with the LDAP server.
Use Secure Connection (SSL): When set to [On], the port number is changed to 636.
When set to [Off], security problems may occur.
Encrypting Network Communication
Authentication: Select the authentication method according to the authentication settings of the LDAP
server.
Kerberos Authentication: Authentication is performed on the KDC server. The password is protected
with encryption and is then sent to the KDC server.
When you select [Kerberos Authentication], specify the following:
User Name, Password: Enter the user name and password of the account that requests
Search to the LDAP server (administrator or representative). For the search request with the
authentication information of the user, do not enter.
You can browse the Address Book instead of entering the user name and password directly.
Realm Name: Select the Realm Name. Register the Realm in advance.
Registering the Realm
Digest Authentication: Authentication is performed on the LDAP server. This method is only available
on a server supporting LDAP version 3.0. The password is protected with encryption and is then sent
to the LDAP server.
Cleartext Authentication: The password is sent to the LDAP server without encryption.
Press [Settings for Administrator] [Authentication/Charge] [Administrator
Authentication/User Authentication/App Auth.] [Register/Change/Delete LDAP
Server].
Select a Not Registered item, and then press [Register/Change].
Enter the information for the LDAP Server.
To Next Page
Loading...
