4. Specify the Original Orientation.
If the display of this screen is not necessary when you press [Start], clear the [Check
the orientation of the original every time after pressing [Start]] check box.
Placing of the original is completed.
5. Press [Original Thickness] to specify the original thickness as necessary.
• If the key is not displayed, select it from [Original Setting/Store File].
• If you specify an original thickness, originals will be scanned at the speed and
setting suitable for that thickness. This setting can be used only when the One-
pass duplex scanning ADF is attached.
6. Select the color mode.
7. Press [ ] or [ ] in [Quantity] to specify the number of copies.
You can enter this using the keyboard after pressing [Quantity] or a number.
To Next Page
Loading...
