Problem Causes Solutions
Copies are too light. Toner container is almost
empty.
Add toner. For details, see "Adding
Toner", About This Machine .
Copies are blurred. Continuous copies have been
made on small sized paper.
Wait about two minutes, and then try
coping again.
Black lines appear. The exposure glass or platen
plate is dirty.
Clean the exposure glass or platen
plate. See
"Maintaining Your Machine",
About This Machine
.
White lines appear. The exposure glass or platen
plate is dirty.
Clean the exposure glass or platen
plate. See
"Maintaining Your Machine",
About This Machine
.
White lines appear. When is blinking, toner is
beginning to run out.
Add toner. For details, see "Adding
Toner", About This Machine .
Copies are blank. The original is not set
correctly.
When using the original table, face the
originals down.
For details, see "Placing
Originals", Copy and Document Server
Reference
.
A moire pattern is produced
on copies.
The original has a dot pattern
image or many lines.
Place the original on the original table
at a slight angle.
Wrinkles appear on the copy. The paper is damp. • Replace the paper with new paper.
•
Turn on the anti-humidity heater
switch to prevent paper absorbing
moisture. For details, see "Guide to
Components", About This Machine
.
When You Cannot Make Clear Copies
29
To Next Page
Loading...
