Message Causes Solutions
"Load following paper in n.
[Job Reset]."
(A figure is placed at n.)
The printer driver settings are
incorrect or the tray does not
contain paper of the size
selected in the printer driver.
Check that the printer driver settings are
correct, and then load paper of the size
selected in the printer driver into the input
tray. For details about how to change the
paper size, see "Changing the Paper
Size", About This Machine .
"Paper size and type are
mismatched."
"Change the setting to
continue the current job or
press [Job Reset]."
The printer driver settings are
incorrect or the tray does not
contain paper of the size or
type selected in the printer
driver.
Check that the printer driver settings are
correct, and
then load paper of the size
and type selected in the printer driver
into the input tray. For details about how
to change the paper size, see
"Changing the Paper Size", About This
Machine
.
"Paper size of _%_ is
mismatched. Change the
setting to
continue the current
job or press [Job Reset]."
The size of the paper in the
specified tray
does not match
the size of the original.
Open the Printer Properties dialog box
and make sure that [Automatically
Select] is not specified as the [Paper
Source:] setting. Select the tray
manually. Depending
on the size of your
original, the roll that is set might be too
small so some areas of image might be
lost.
"Problem: Printer Font Error" An error has occurred in the
font settings.
Contact your service representative.
"The selected file(s)
contained file(s) without
access privileges.
Only file(s)
with access privileges will be
deleted."
You have tried to delete files
without the
authority to do so.
Files can be deleted by the person who
created the file. To delete a file which
you are
not authorized to delete, contact
the person who created the file.
"Updating the destination
list... Please wait. Specified
destination(s) or sender's
name has been cleared."
The destination list is being
updated from the network
using Web Image Monitor.
Wait until the message disappears. Do
not switch off the power while this
message is
displayed. Depending on the
number of destinations to be updated,
there may be some delay before you
can resume operation. Operations are
not possible while this message is
displayed.
Messages Displayed When Using the Printer Function
43
To Next Page
Loading...
