Exterior Covers
• Turn off the main power switch and unplug the printer before you do the procedures in this section.
Rear Cover
1. Rear tray cover [A] (hooks)
2.
Interface cover [B] (hooks)
3. Rear cover [C] ( x 4)
• After removing four screws from the rear cover, pull the rear cover from the top right [D] to the top
left while lifting up the rear cover
•
Upper screw [E]: "M3x8" x 2, Lower screws [F]: "M4x10" x 2
Exterior Covers
25
To Next Page
Loading...
