3. Press [System Settings].
4. Press [Settings for Administrator] [Security] [Network Security Level].
5. From the list next to Network Security Level, select a security level.
Select a security level from among Level 0, Level 1, Level 2, and FIPS 140.
For the security levels, see Security Level Setting List.
If you have customized the security level using Web Image Monitor, [Custom] is
selected. You cannot enable [Custom] from the control panel. To customize the
security level, use Web Image Monitor.
6. Press [OK].
7. Press [Home] ( ), and then log out of the machine.
1. Log in to the machine as the network administrator from Web Image Monitor.
Logging in to the Machine as an Administrator
When custom-privileges administrators are registered, you can log in to the machine as a
custom-privileges administrator with the Security privilege as well.
Logging in to the Machine as a Custom-Privileges Administrator
2. Click [Configuration] on the [Device Management] menu.
Section Top
Specifying the Security Level Using Web Image Monitor
To Next Page
Loading...
