Paper is jammed. See the animated illustration displayed
on the control panel, and remove the
jammed paper.
When Paper or an Original Is
Jammed
An original has jammed. See the animated illustration displayed
on the control panel, and remove the
jammed original.
When Paper or an Original Is
Jammed
Toner is almost depleted, or has run
out.
Prepare a replacement toner. Replace
the toner when it runs out.
Replacing the Toner
If appears when there is a lot
of toner, pull out the print cartridge
by following the toner replacement
procedure that is displayed on the
screen, and then set it back again.
The waste toner bottle is full, or almost
full.
Prepare a replacement waste toner
bottle.
Replace the bottle when it becomes full.
Replacing the Waste Toner Bottle
Staples are nearly depleted, or have
run out.
Prepare a cartridge for replacement,
and load it when the staples run out.
Replenishing the Staples
The hole punch receptacle is full. Empty the receptacle.
When the Hole Punch Receptacle
Is Full
A cover is open. Check that all covers of the machine
and external devices are closed.
To Next Page
Loading...
Need help?
General
