Ricoh MP C2011

Problems Causes Solutions
Misfeeds occur frequently. The tray's side or end fences
may not be set properly.
• Remove the misfed paper. For
details about removing jammed
paper, see "Removing Jammed
Paper", Troubleshooting.
• Check that the side or end fences
are set properly. For details about
setting the side and end fences,
see "Changing the Paper Size",
Paper Specifications and Adding
Paper.
Misfeeds occur frequently. Paper of undetectable size
has been loaded.
• Remove the misfed paper. For
details about removing jammed
paper, see "Removing Jammed
Paper", Troubleshooting.
• If you load a paper size that is not
selected automatically, you need
to specify the paper size with the
control panel. For details about
specifying paper size with the
control panel, see "Changing to a
Size That Is Not Automatically
Detected", Paper Specifications
and Adding Paper.
Cannot print in duplex
mode.
You have selected a paper
tray that is not set for duplex
printing.
Change the setting for "Apply Duplex"
in [System Settings] to enable duplex
printing for the paper tray. For details
about setting "Apply Duplex", see
"Tray Paper Settings", Connecting the
Machine/ System Settings.
Cannot print in duplex
mode.
You have selected a paper
type that cannot be used for
duplex printing.
In [System Settings], select a paper
type that can be used for duplex
printing. For details about setting
"Paper Type", see "Tray Paper
Settings", Connecting the Machine/
System Settings.
When You Have Problems Operating the Machine
137