Ricoh P 501 - Page 102

Message Cause Solution
"IPv6 Address already exists
Stateless
Address(109/209)"
The same IPv6 address is already
used.
Contact your network
administrator.
"IPv6 Address already exists
Manual Config.
Address(109/209)"
The same IPv6 address is already
used.
Contact your network
administrator.
"Load paper in (tray name)" There is no paper in the specified
tray.
Load the specified paper in the
tray, press [JobReset] to reset the
job.
"No privileges to use funct." The logged in user does not have
the privileges to register programs
or change the paper tray settings.
For details about how to set
permissions, see Security.
"Option RAM Error" The machine cannot detect an
optional SDRAM module.
Check that the SDRAM module
installed correctly.
"Parallel I/F Error" The machine's self-diagnostic test
failed due to a loopback error.
Replace the IEEE 1284 board that
caused the error.
"Printer Font Error." There are problems with the
machine's font file.
Turn the machine off, and then
turn it on again.
If the problem persists, contact
your sales or service
representative.
"Problem with Hard Disk
Please call service."
The machine cannot detect the
hard disk.
Check that the hard disk installed
correctly. If the problem persists,
contact your sales or service
representative.
"Problem:Wireless card
Please call service."
The machine cannot detect a
wireless LAN interface board.
Check that the wireless LAN
interface board installed correctly.
If the problem persists, contact
your sales or service
representative.
5. Troubleshooting
100