6
Settings
100
You can set the brightness, saturation, and color adjustment of
the monitor.
1 Select [LCD Display Settings] in the D1 menu
and press D.
The [LCD Display Settings] screen appears.
2 Adjust the brightness,
saturation, and color.
Available operations
3 Press E.
The D1 menu reappears.
u Caution
• When [Outdoor View Setting] of the D1 menu is set, [LCD
Display Settings] cannot be changed.
You can set whether to turn on the lights for the following
camera parts when 8 is pressed.
Set in [Illumination Settings] of the
D2 menu. Selecting [Off] provides no
illumination even when 8 is
pressed.
You can set whether to light up the following indicator lamps on
the camera body.
Set in [Indicator Lamps] of the D2
menu.
For [Self-timer], the self-timer lamp
blinks during the countdown for the
drive mode [Self-timer (12 sec.)]. For
[Remote Control], the remote control
receiver lamp blinks during the
standby for shooting.
Setting the Monitor and Indicator Lamps
Adjusting the Brightness, Saturation, and
Color of the Monitor
D1
AB Selects a parameter.
CD Adjusts the value.
R
Switches between the color chart display
and the image display.
M Resets the adjustment value to the default
setting.
±0
LCD Display Settings
Brightness Level
OK
Cancel
Specifying the Illumination Button
Settings
D2
LCD Panel Off, Low, High
Backside Controls Off, Low, High
Lens Mount Off, On
Card Slot/Connector Off, On
Setting the Illumination of the Indicator
Lamps
D2
Wi-Fi Off, Low, High
GPS Off, Low, High
Self-timer Off, On
Remote Control Off, On
Pressing the illumination button
Pressing the illumination button
will provide high illumination
will provide high illumination
for the LCD panel
Illumination Settings
LCD Panel
Backside Controls
Lens Mount
Card Slot/Connector
Wi-Fi
GPS
Indicator Lamps
Self-timer
Remote Control
To Next Page
Loading...
