Ricoh PENTAX K-1 II - Interval Shooting

3
Shooting
68
1 Select q on the Drive
Mode screen and press B.
2 Use CD to select q, U, V, or w.
Proceed to Step 6 if you do not need to change the shooting
conditions.
3 Press G.
4 Set the shooting
conditions.
5 Press E.
The screen of Step 1 reappears.
6 Press E.
The camera returns to standby mode.
7 Press 0.
When [Start Interval] is set to [Now], the first picture is
taken. When set to [Set Time], shooting starts at the set
time.
To cancel shooting, turn the main switch to [OFF].
After the specified number of shots are taken, the camera
returns to standby mode.
Interval Shooting
q
Interval Shooting
Takes pictures at set intervals and saves them.
U
Interval Composite
Takes pictures at set intervals and merges them
into a single image.
V
Interval Movie Record
Takes still pictures at set intervals and saves
them as a single movie file (Motion JPEG, file
extension: .AVI).
w
Star Stream
Takes still pictures at set intervals and merges
them into a single movie file (Motion JPEG, file
extension: .AVI) using Interval Composite.
00020002
00
:
00´02˝00
:
00´02˝
Interval ShootingInterval Shooting
CancelCancel
Parameter Adj.Parameter Adj.
IntervalInterval
Number of ShotsNumber of Shots
OKOK
timestimes
Start IntervalStart Interval
00
:
00´02˝
00
:
00´02˝
0002
0002
--
:
--
--
:
--
Interval Shooting
Interval Shooting
Interval
Interval
Start Interval
Start Interval
Number of Shots
Number of Shots
times
times
Cancel
Cancel
OK
OK
Start Time
Start Time
Recorded Pixels
Select from z, u, or t (only for
V and w).
Interval Select from 2 seconds to 24 hours.
Standby Interval
Select from the minimum time or 1
second to 24 hours.
Number of Shots
Select from 2 to 2000 times (from 8 to
2000 times for V and w).
Start Interval
Select when and how to take the first
picture from [Now], [Self-timer],
[Remote Control], or [Set Time].
Start Time
Set the shooting start time when [Start
Interval] is set to [Set Time].
Composite Mode
Select from [Average], [Additive], or
[Bright] (only for U).
Save Process
Select Z to save images in the
middle of processing (only for U).
Fade-out
Select the fade-out effect level of light
trails (only for w).