3
Shooting
72
Available operations
3 Press E.
4 Press F.
The camera returns to standby mode.
t Memo
• The flash modes that can be selected vary depending on the
capture mode.
• When the flash is used in J mode, the shutter speed
automatically changes over a range from 1/200 seconds to a
slow shutter speed depending on the lens being used. The
shutter speed is locked at 1/200 seconds when a lens other
than a D FA, DA, DA L, FA, FA J, or F lens is used.
• When the flash is used in I, K, or L mode, any desired
shutter speed of 1/200 seconds or slower can be set.
• When [Flash Mode] is assigned to X or Y, you can display
the Flash Mode screen in Step 2 by a simple button operation.
(p.97)
1 Press D in standby mode.
The Custom Image setting screen appears.
2 Select an image finishing
tone.
Available operations when shooting with the
viewfinder
Proceed to Step 6 when [Auto Select] is selected or if you
do not need to change the parameters.
D
Flash On
+ Red-eye
Discharges a pre-flash for red-eye
reduction before the main flash for
each picture.
E
Slow-
speed Sync
Sets to a slow shutter speed and
discharges a flash for each picture.
Use this, for example, when shooting a
portrait with the sunset in the
background.
F
Slow Sync
+ Red-eye
Discharges a pre-flash for red-eye
reduction before the main flash is
discharged with Slow-speed Sync.
R Compensates the flash exposure.
M Resets the compensation value to the
default setting.
Capture Mode Selectable Flash Mode
R
A, B, C, D
G, H, J C, D, E, F
I, K, L, M, N
C, D
Controlling the Image Finishing
Tone
Custom Image
Auto Select
Bright
Natural
Portrait
Landscape
Vibrant
Radiant
Muted
Flat
Bleach Bypass
Reversal Film
Monochrome
Cross Processing
Main switch to U Uses Digital Preview to preview
the background image with the
selected setting applied.
H
Saves the preview image (only
when the image can be saved).
±0
±0
±0
+1
+1
Bright
Cancel
Parameter Adj.
Check
OK
To Next Page
Loading...
