Technical Bulletin PAGE: 6/8
Model: Vacuum Feed LCIT RT5100
2. Measure the clearance between the bent portions of the side plate and the bearing
flange by shifting the bottom plate to the rear side (both the Upper (Fig. 10) and Lower
(Fig. 11) positions).
Upper Position
Fig. 10
Lower Position
Fig. 11
Target dimensions:
a. Span between the two side plates (Fig.8, 9): 446.8 – 448.4 mm
b. Clearance (Fig. 10, 11): 0.5 – 3.0 mm
If BOTH the span and clearance are within these dimensions when the tray is in BOTH
positions (upper and lower positions), this Rework is complete.
If ANY of these measurements is not within the dimensions mentioned above, continue
this procedure.
To Next Page
Loading...
