Ricoh PRO C7210X - Page 244

1.SC Codes
240
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
When the spine fold plate moved from the closed to open position, the spine fold
press sensor (right) was already OFF.
 Spine fold motor (R) connector loose, broken, defective
 Motor defective
 Spine fold press sensor (R) connector loose, broken, defective
 Sensor defective
 Reconnect the connector.
 Replace the spine fold motor (R).
 Replace the spine fold press sensor (R).
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
61
D
Perfect Binder: Right spine fold plate open error
 The spine fold press sensor (right) did not go OFF when the spine fold plate
closed, even while the spine fold motor (right) was operating for 500 ms.
 When the spine fold plate moved from the open to open position, the spine
fold press sensor (right) was already ON.
 Spine fold motor (R) connector loose, broken, defective
 Motor defective
 Spine fold press sensor (R) connector loose, broken, defective
 Sensor defective
 Reconnect the connector.
 Replace the spine fold motor (R).
 Replace the spine fold press sensor (R).
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
62
D
Perfect Binder: Spine fold HP sensor (R) error
The spine fold HP sensor (R) and spine fold press sensor (R) went ON at the
same time.
 Spine fold HP sensor (R) connector loose, broken, defective
 Sensor defective
 Spine fold press sensor (R) connector loose, broken, defective