Setting Items Remarks
Curt:Dist:Fuser Unit
Curt:Dist:Fusing Belt
Curt:Dist:Fusing Rllr
Curt:Dist:Press Rllr
Curt:Dist:Thermistor
Curt:Dist:Separation Pad
Curt:Dist:Fusing Heater
Curt:Dist:Gear Set
Curt:Page:Fuser Unit
Curt:Page:Fusing Belt
Curt:Page:Fusing Rllr
Curt:Page:Press Rllr
Curt:Page:Thermistor
Curt:Page:Separation Pad
Curt:Page:Fusing Heater
Curt:Page:Gear Set
Curt:Paper Feed :Clng Web
Curt:Rot:Clng Web
Curt:Smooting Time
Value display only.
Saved Value specified in Fuser Unit No. is
displayed under Current Value.
Finishing: Finisher
0601 Staple Position: Across Feed 1
Adjust the vertical position of the staple (applied at an edge) when using Finisher SR5050 or Booklet
Finisher SR5060.
Press [ ] to move the stapling position away from the side edge of the sheet or [ ] to move it toward the
edge.
6. Adjustment Settings for Operators
184
To Next Page
Loading...
