EasyManua.ls Logo

Ricoh Pro C9200 - Page 242

Ricoh Pro C9200
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Message Cause Solution
"Shutting down... Please
wait. Main power will be
turned off automatically.
Maximum waiting time: 11
minute(s)"
The shut down procedure
has begun because the
power was turned off while
the machine was in standby
mode or performing an
operation.
Follow the message that appears
and wait until the machine has
shut down. Do not turn on the
power while this message is
displayed. If the power has been
turned on, follow the message
that appears. For details about
turning on and off the power, see
page 69 "Turning On/Off the
Power".
The shutdown time varies
according to the options that are
installed and the environmental
conditions of the location where
the machine is set up. If the main
power indicator remains lit after
15 minutes have elapsed, contact
your service representative.
"The power cord(s) has been
disconnected or the breaker
switch is turned off. Turn the
main power off, plug in the
cord(s) to the wall outlet,
and then turn the breaker
switch on."
One of the two power
cords is not plugged
into the wall outlet.
The earth leakage
breaker is in the Off
position.
Securely plug the two power
cords directly into the wall outlet.
For details about the power
connection, see page 274
"Where to Put Your Machine".
For details about handling the
earth leakage breaker, see
page 281 "Checking the Earth
Leakage Breakers".
7. Troubleshooting
240

Table of Contents

Other manuals for Ricoh Pro C9200

Related product manuals