Item Description
LAN Type Switch the interface between Ethernet and wireless LAN. This is available only if
the device supports both interfaces.
Network Displays Ethernet operation status.
MAC Address Displays the MAC address (Media Access Control Address) of the network
interface board.
I/O timeout
(Network)
Select whether or not to apply a timeout limit if the machine takes longer than a
specified time to process a job.
Ethernet Speed Ethernet communication speed. For normal use, select Auto Select. This allows
the device to select the optimum speed.
If communication with the device fails, select 10Mbps Full Duplex, 10Mbps
Half Duplex, 100Mbps Full Duplex, or 100Mbps Half Duplex.
Configuring the IPv4 settings
Click [IPv4] to display the page for configuring the IPv4 settings.
• In [LAN Type] in [Interface Settings], you can select [Ethernet] to display the wired LAN IP address,
or [Wireless LAN] to display the wireless LAN IP address.
4. Configuring the Machine Using Utilities
40
To Next Page
Loading...
