Ricoh SP 200S - Specifying Paper Type and Paper Size Using Smart Organizing Monitor

Specifying a custom paper size
1. Press the [ ] key.
CTT006
2.
Press the [ ] or [ ] key to select [System Settings], and then press the [OK] key.
To specify the size of paper in the bypass tray, select [Copier Features], and then press the [OK]
key.
3. Press the [ ] or [ ] key to select [Tray 1 Ppr Settings], and then press the [OK] key.
To specify the size of paper in the bypass tray, select [Bypass Ppr Settings], and then press the
[OK] key.
4. Press the [
] or [ ] key to select [Paper Size], and then press the [OK] key.
5. Press the [ ] or [ ] key to select [Custom], and then press the [OK] key.
6. Press the [ ] or [ ] key to select [mm] or [inch], and then press the [OK] key.
7. Press the [ ] or [ ] key to specify the width, and then press the [OK] key.
8. Press the [ ] or [ ] key to specify the length, and then press the [OK] key.
9. Press the [OK] key.
10. Press the [ ] key to return to the initial screen.
Specifying Paper Type and Paper Size Using Smart Organizing Monitor
The procedure in this section is an example based on Windows 7. The actual procedure may vary
depending on the operating system you are using.
Specifying the paper type and paper size
1. On the [Start] menu, click [All Programs].
2. Click [Smart Organizing Monitor for SP xxx Series].
3. Click [Smart Organizing Monitor for SP xxx Series Status].
Loading Paper
33