Ricoh SP 200S - Page 348

13
3. Changing the IP Address Settings
Changing the IP Address Settings Using the Control Panel (SP
202SF only)
Configuring the Machine Settings to Obtain an IPv4 Address Automatically
1. Press the [ ] key.
2. Press the [
] or [ ] key to select [Network Settings], and then press the [OK] key.
3. Press the [
] or [ ] key to select [Machine IPv4 Address], and then press the [OK]
key.
4. Press the [ ] or [ ] key to select [DHCP Activated], and then press the [OK] key.
5. Make sure [DHCP Activated] is set to [On].
After a setting has been changed, the machine automatically restarts.
Configuring the Machine's IPv4 Address Manually
1. Press the [ ] key.
2. Press the [
] or [ ] key to select [Network Settings], and then press the [OK] key.
3. Press the [
] or [ ] key to select [Machine IPv4 Address], and then press the [OK]
key.
4. Press the [ ] or [ ] key to select [DHCP Activated], and then press the [OK] key.