Ricoh SP 230SFNw - Page 223

5-18
Confidential
 Adjust upper-end print position
<Function>
In the event that the upper-end print start position deviates, use this function to adjust the
position up and down. Adjustable range is -50 to 50 (1 unit = 0.084 mm = 300 dpi).
(Shifted down when the value is negative)
<Operating Procedure>
(1) Press the [4], and then the [5] in the initial state of maintenance mode. For models
without keypad, press the [▲] or [▼] to display “MAINTENANCE 45” on the LCD and
press the [OK]. “USBNo.” is displayed on the LCD.
(2) Press the [▲] or [▼] to display “Y Adjust” on the LCD, and press the [SET] or [OK].
“YAdjust T1” is displayed on the LCD.
(3) Refer to <Adjustment option table> in the table below, press the [▲] or [▼] to select from
the adjustment options, and press the [SET] or [OK]. “YAdj. **= 0*” is displayed on the
LCD. (Selected option is shown for **.)
(4) To shift the writing start position down, press the [▼] to decrease the value. To shift the
position up, press the [▲] to increase the value.
(5) Press the [SET] or [OK] after adjusting the value. “Accepted” is displayed on the LCD.
(6) Press the [X] or [Stop], and the machine returns to the initial state of maintenance mode.
<Adjustment option table>
*1
Adjusts first side print start position of all tray (paper tray). Value of Y Adjust TRAY and Y
Adjust DX is added to each tray adjustment value.
For example, when printing from paper tray, it adjusts as “Y Adjust T1 value” + “Y Adjust
TRAY value” or “Y Adjust DXT1 value” + “Y Adjust DX value” and print. Besides, when the
added value is over than the adjustable range (-50 to 50), adjusted value will be for
minimum -50 and maximum 50 and does not become out of adjustable range.
*2
Adjusts second side print start position of all tray (paper tray). Value of Y Adjust TRAY is
added to each tray adjustment value.
For example, when printing from paper tray, it adjusts as “Y Adjust T1 value” + “Y Adjust
TRAY value” and print. Besides, when the added value is over than the adjustable range
(-50 to 50), adjusted value will be for minimum -50 and maximum 50 and does not become
out of adjustable range.
Single-side printing Duplex printing
Adjustment option LCD Adjustment option LCD
Paper tray first side Y Adjust T1 Paper tray second side Y Adjust T1
*1 Y Adjust TRAY *2 Y Adjust TRAY
N/A (disabled) Y Adjust DX *1 Y Adjust DX
N/A (disabled) Y Adjust DXT1 Paper tray first side Y Adjust DXT1