2-23
Confidential
Jam Inside Open the Front
Cover, pull out the
Drum Unit
completely and
remove the jammed
paper.
After the registration rear sensor
detects paper pass, the eject
sensor does not detect paper
pass.
7000 2-42
Jam Rear Open the Back
Cover and remove
the jammed paper,
then press Go.
After the registration rear sensor
detects the end of paper pass
and the specified period of time
has passed, the eject sensor
continues to detect paper pass.
7100 2-43
Jam Tray 1 Remove the
jammed paper from
Tray 1.
When printing from the paper
tray, the registration front sensor
does not detect paper pass
within the specified time after
the T1 paper feed sensor
detected paper pass.
7302 2-43
Journal Full -
The number of the registered
communication management
reports reached 200.
--- 4.14.5
Machine Error -
Detected that the modem PCB
is not connected.
D200 2-54
Machine Error
F9
-
The spec code was not entered
correctly.
F900 2-55
Manual Feed Load Paper.
There is no paper set in the
manual feed slot on the manual
feed slot printing.
8C00 2-45
Media
Mismatch
Reload correct
paper in Tray 1,
then press Go.
When printing from the paper
tray, paper type setting in the
machine does not match the
setting in the driver.
9202 2-46
No Drum Unit Open the Front
Cover, then install
the Drum Unit.
Detected that the drum unit was
not set by detecting the grid
terminal current.
6200 2-40
No Paper Reload paper in
Tray.
Detected that there was no
paper set in all trays when
TrayAuto was selected for
printing.
9309 2-48
Detected that there was no
paper set in all trays when
TrayAuto was selected for
printing.
(At List printing)
--- 4.2.1
Error message
Description
Error
codes
Refer
to:
Initial display Scroll
To Next Page
Loading...
