Ricoh SP 330DN - Page 138

5.System Maintenance
126
Menu
Description
Setting
Remote
Service
CE Call
Performs the CE Call at the start or end of the service.
Function Flag
Enables or disables the remote service function.
[Disable (Default)/ Enable]
Communication Test
Executes the communication test.
Device Information
Call
Executes the device information notification.
RCG Reg. State
Displays the RCG registration status.
[0 to 2]
GW URL
Displays the URL for RCG center.
Polling Interval
Sets the polling interval.
[0 to 4294967295 / 60 / 1 sec/step]
Connection Timeout
Specifies the connect timeout interval when calling the RCG.
[1 to 90 / 30 / 1 sec/step]
Send Timeout
Specifies the send timeout interval when calling the RCG.
[0 to 100 / 30 / 1 sec/step]
Receive Timeout
Specifies the receive timeout interval when calling the RCG.
[0 to 100 / 30 / 1 sec/step]
Retry Interval
If the HTTP connection fails, specify the interval at which the
connection will be retried again.[0 to 65535 / 3 / 1 sec/step]
Retry Count
If the HTTP connection fails, specify the number of times to
retry the connection.
[0 to 255 / 3 / 3 counts/step]
Connect Send Delay
Specifies the connection request sending delay.
[0 to 255 / 5 / 1 sec/step]
Max Multipart
Specifies the maximum number of multipart.
[0 to 10 / 10 / 1/step]
Rescue URL
Displays the rescue URL.
Regular Notify Kind
Sets the periodic notification mode.
[0 to 5 / 0 / 1/step]
Counter Notify Kind
Sets the counter notification mode.
[0 to 5 / 0 / 1/step]
Regular Notify
Timing
Displays the periodic notification date and time.
Counter Notify
Timing
Displays the counter notification date and time.
Counter Closing
Displays the counter closing date and time.