3. Lift the machine using the inset grips on both sides of the machine.
4. There are three upright pins on the optional paper feed unit. Align the holes of the
machine with the pins, and then lower the machine slowly.
5. Insert the power plug into the wall outlet, and then turn on the power.
• After installing the optional paper feed unit, select Tray 2 in the printer driver. For details, see the
printer driver Help.
• If the new device is listed in the column of configuration options, it has been properly installed.
• If the optional paper feed unit is not installed properly, try to install it again by repeating the
procedure. If the problem persists, contact your sales or service representative.
• For details about printing the configuration page, see page 89 "List/Test Print Menu".
Installing the Wireless LAN option
• Before using the option, you must configure settings from the control panel. For details, see Setup
Guide.
Installing Option
19
To Next Page
Loading...
