Default: 0 for all parameters
• Horiz.: Tray 1
Select this to adjust the tray 1 registration horizontally.
• Vert.: Tray 1
Select this to adjust the tray 1 registration vertically.
• Horiz.: Tray 2
Select this to adjust the tray 2 registration horizontally.
• Vert.: Tray 2
Select this to adjust the tray 2 registration vertically.
• Horiz.: Bypass Tray
Select this to adjust the bypass tray registration horizontally.
• Vert.: Bypass Tray
Select this to adjust the bypass tray registration vertically.
• Horiz.: Duplex: Back
Select this to adjust the registration of the back of duplex printing horizontally.
• Vert.: Duplex: Back
Select this to adjust the registration of the back of duplex printing vertically.
Low Humidity Mode
If the machine is used in a room where humidity level is low, black lines of a few millimeters thick
may appear on printouts with 75-millimeter spaces in between. Selecting [On] for this setting may
prevent these lines from appearing (wait for about one day until this setting becomes effective).
Note that when this setting is enabled, the machine automatically performs self-maintenance in
every 10 minutes.
Default: [Off]
• Off
• On
Image Density
Adjusts the density of images on prints.
Default: [0]
• -3 to +3
System Settings Menu
81
To Next Page
Loading...
