Message Cause Solution
"Cannot print." The printer cannot print the
sent data.
Check that the file you want to
print is a supported file type.
Check the misfeeds and ask
your network administrator for
help.
"Change (Tray name) to the
following settings:"
The size of the paper in the
tray does not match the paper
size specified in the printer
driver.
Select a tray containing paper
that is the same size as the
specified paper size.
"Check network settings.
(103/203)"
The IP address setting is
incorrect.
Check the IP address, subnet
mask, and gateway address.
"Classification Code Error" A classification code is not
specified for the print job.
Enter a classification code
using the printer properties
and print the document again.
"Connect failed:WirelessCard Turn
power off, check card."
The printer cannot detect the
wireless LAN interface board.
Check that the board is
supported or installed
correctly.
"Cover Open. Please close the
indicated cover."
A cover of the printer is open. Close the cover as indicated
on the control panel.
"Duplex mode is in off position for
(tray name)"
The duplex mode for the
indicated tray is not available.
You can use one-sided
printing only. Press [Change]
to change the tray's settings,
press [JobReset] to reset the
job, or press [Form Feed] to
force printing.
"Ethernet Board Error" An error on the Ethernet is
detected.
Turn the printer off, and then
turn it on again. If the problem
persists, contact your sales or
service representative.
"Exceeded max. No. of files." While printing a Sample Print,
Locked Print, Hold Print, or
Stored Print file, the maximum
file capacity was exceeded.
Delete unneeded files stored in
the printer.
When Messages Are Displayed
61
To Next Page
Loading...
Need help?
General
Weight and Dimensions
