• User Authentication (Copy)
Specifies how many seconds a user stays authenticated after paper is output when copying
with the exposure glass. Note that authentication for other functions will expire immediately
after using that function.
This setting appears only for the Type 2 model (when the user restriction function is enabled
via Web Image Monitor).
Default: [30 seconds]
• 5 to 60 seconds, in increments of 1 second
• Fixed USB Port
Specifies whether the same printer/LAN-Fax driver can be used for multiple machines or not
under USB connection.
Default: [Off]
• Off
You must install the printer/LAN-Fax driver separately for individual machines, because
the machine other than the original will be recognized as a new device upon USB
connection.
• On
The same printer/LAN-Fax driver you have installed in your computer can be used with
any machine other than the one originally used for installation, if the machine is of the
same model.
Auto Continue
Sets the machine to ignore an error with paper size or type and continue printing. The printing stops
temporarily when an error is detected, and restarts automatically after about ten seconds using the
settings made on the control panel. However, if the size of paper specified on the control panel
and that of the paper loaded in the paper tray or the paper size specified for the print job do not
match when printing restarts, it may cause a paper jam.
Default: [Off]
• Off
• On
Toner Saving
Sets the machine to print using a reduced amount of toner (for prints made by the copier function
only).
Default: [Off]
• Off
• On
System Settings
211
To Next Page
Loading...
Need help?
General
Weight and Dimensions
