Initial Setup
Initial Setup
When you turn on the machine for the first time, a menu for configuring the settings described below will
appear on the display. This section explains how to complete the Initial Setup.
• (mainly North America): The fax number code is required by international law. You
cannot legally connect a fax machine to the telephone system if the fax number code is not
programmed. Also, the fax header code and the date and time of transmission must be included in
the header of all pages faxed to, from, or within the United States.
• Make sure to select the correct code for the country of use. Selecting the wrong country code may
cause failures in fax transmissions.
Display language
The selected language here is used for displaying messages, etc.
User fax number
The registered number is used as the fax number of the machine. The user fax number can contain
0 to 9, spaces, and "+".
User name
The name entered here is used as the name of the fax sender.
Country code
The selected country code is used for configuring the time and date display formats, and the
settings related to fax transmissions with appropriate default values for the country of use.
Press the [
] or [ ] key to select the item you want to configure, and enter the number or name (up to 20
digits or characters) if necessary, then press the [OK] key.
• For details about entering characters, see page 146 "Entering Characters".
• You can change the settings configured during the Initial Setup later in the [Admin. Tools] menu.
You can also configure the time and date in the [Admin. Tools] menu. For details about [Admin.
Tools], see page 228 "Administrator Settings".
• If the [Print Fax Header] setting under fax transmission settings enabled, the registered user fax
number, user name, and time and date of transmission appear on the header of every fax you
send. For details about [Print Fax Header], see page 200 "Fax Transmission Features Settings".
1. Getting Started
34
To Next Page
Loading...
Need help?
General
Weight and Dimensions
