3. Squeeze the clip on the side paper guide and slide it to match the paper size.
4. Squeeze the end guide and slide it inward to match the standard size.
5. When loading paper into tray 1, slide the two switches at the bottom of the tray
according to the thickness of the paper.
If the paper is 164 g/m
2
(44 lb.) or thicker, slide both switches into the rear (thick) position. If the
paper is lighter than 163 g/m
2
(43 lb.), slide both switches into the forward (thin) position.
6. Set the paper straight down on the paper source tray with its printing side facing up.
Make sure paper is not stacked higher than the upper limit (upper line) marked inside the tray.
Loading Paper into Paper Trays
43
To Next Page
Loading...
