Other Printing Problems
This section describes likely causes of and possible solutions for problems that can occur when a print
job is performed from a computer.
When You Cannot Print Properly
Problem Cause Solution
The printed image is smudged. Settings for thick paper have
not been configured when
printing on thick paper in the
bypass tray.
PCL 5c:
On the printer driver's [Paper]
tab, select [Bypass Tray] in the
"Input Tray:" list. Then in the
"Type:" list, select a proper
paper type.
PCL 6/PostScript 3:
On the printer driver's [Detailed
Settings] tab, click [Paper] in
"Menu:", and then select [Bypass
Tray] in the "Input Tray:" list. Then
in the "Paper Type:" list, select a
proper paper type.
Printed images contain blots or
are patchy.
The paper is damp. Use paper that has been stored
in the recommended temperature
and humidity conditions. For
details about the proper way to
store paper, see page 39 "Paper
Precautions".
Printed images contain blots or
are patchy.
The printer is not on a level
surface.
The printer must be placed on a
stable and level surface. Check
the printer environment and
select an appropriate location.
For details about the printer's
environment, see "Install
Location", Operating Instructions.
Printed images contain blots or
are patchy.
The LED heads is dirty. Clean the LED heads. For details,
see "Cleaning the LED Heads",
Operating Instructions.
Other Printing Problems
83
To Next Page
Loading...
Need help?
General
Weight and Dimensions
