62
iOS system:
1. When the APP is enabled for the rst time, if the position service is enabled, it will prompt
whether to not 「"WG-M1” would like to use your current location」; if the position service
is disabled, it will prompt 「Turn on location services to allow "WG-M1" to determine your
location」; and if clicking 「setting」, the smart device position service setting interface will
appear.
2. When the APP is enabled for the second time or later, status of position service will be as
follows:
Position service
state selected
at the rst-time
enabling of the APP
The second-time or later enabling of the APP
The position service is
enabled
The position service is Off
Enable Enable the position service
A prompting message 「Turn on location
services to allow "WG-M1" to determine
your location」will appear; and if clicking
「setting」, the smart device position service
setting interface will appear.
Off
A prompting message that「Location services is disabled for WG-M1.
Please exit WG-M1 , then go to ‘Settings; General; Location Services’ and
enable the service for WG-M1.」; and if clicking 「OK」, the APP home
interface will appear. Besides, the position service will be automatically
disabled.
To Next Page
Loading...
