89
Caution:
• Make sure to x this product on a at surface without irregularities or roughness after wiping off
dirt or oil on it.
• Do not twist this product forcedly after xing since its adhesion may weaken. Make sure to use
an optional double-sided adhesive tape (WG Repair Parts 1 O-CM1474) for replacing a used
adhesive instead of reusing it.
• Remove this product carefully. Otherwise, the mounting surface may damage or its painting may
peel off depending on the conditions.
• The nut may loosen during the travelling. Make sure to follow the proper procedures to install
this product securely.
• We shall not be held liable for any damages, malfunctions, losses or accidents of your camera
or this product resulting from tipping over or dropping the product.
To Next Page
Loading...
