Boot Output
➥Power Settings
Disable Output will remain OFF until the “ON/OFF” button is pushed.
Enable Turn on the output automatically upon Boot-up.
LastState Return to the ON/OFF state from the last RD600x shut-off.
This option is for the RD60xx’s output when the “Power” button is pressed (Boot-up).
For behaviour when the RD60xx unit first receives power from the Primary Power
Supply, use the ‘Power State’ setting.
CC Buzzer
➥Buzzer
ON Buzzer sounds continuously (for 30 seconds) when in Constant Current (CC) mode.
OFF Buzzer does NOT sound when in CC mode.
This option does NOT affect the operation of the ‘CV->CC Beep’ option.
CC Buzzer {CS menu}
Same as ‘CC Buzzer’, above, except:
Operation returns to ‘CC Buzzer’ value on next Power-On.
Charge Buzzer
➥Battery Charger
ON Buzzer sounds once when a Battery Charging cycle completes.
OFF Buzzer does NOT sound when a Battery Charging cycle completes.
Comm Buzzer
➥Communication
ON Buzzer sounds once when the software writes new parameter(s) .
OFF Buzzer does NOT sound when Parameter(s) changed.
To Next Page
