Riden RD6012 - Page 42

42
Timer Mode {CS Menu}
OFF Output Timer is NOT enabled.
Single Output ON/OFF will go through ‘Timer Off’ and ‘Timer On’ once.
Cyclic Output ON/OFF continuously cycles through ‘Timer Off’ and ‘Timer On’,
IF ‘Timer Off’ is set to 000000, Timer Mode will not do anything.
IF set to Single, will need to be re-enable after each use.
Notes:
Timers start when the “ON/OFF” Button is pressed, unless ‘Timer Reset’ is
enabled.
Changing the ‘Timer Mode’ settings while the output is ON may result in
unexpected behaviour.
Setting is automatically disabled on power-down.
Timer Off {CS Menu}
Settable Range: 000000 - 995959 (Hours, Minutes, Seconds)
IF Set to 000000, ‘Timer Mode’ will not activate.
IF Timer Mode active:
When value reaches 000000, output will turn OFF.
IF ‘Timer On’ is set to 000000,
When ‘Timer Off’ expires:
Output will turn OFF.
The Normal Operating Mode indicator is replaced by a white on red
background ‘TIME’ icon.
Timer On {CS Menu}
Settable Range: 000000 - 995959 (Hours, Minutes, Seconds)
IF Timer Mode active:
After ‘Timer Off’ expires and the output is turned OFF.
‘Timer On’ will then start counting down.
When ‘Timer On’ expires, the output will turn back ON.