- 12 -
6. Move the brackets upwards and rotate for releasing them from the retaining bushing.
Follow the instructions below to remove the fixing brackets without releasing the front panel (*).
7. Remove the 4 fixing screws of the
frontal wooden beam of the pallet.
8. Remove the end wooden support,
and ensure that the product is held
stable during this process .
9. Guide the product towards the front of
the pallet with caution; the pallet will
begin to tilt down acting as a ramp;
continue to move the product down off
the pallet.
(*) If it will be difficult to remove the brackets, unhook the front panel pulling it from the edges; the front panel is hooked with a
system of pins and springs, tools are not needed.
To Next Page
Loading...
