What does it mean when my Riello UPS display shows the code A11?
The code A11 on the Riello UPS display indicates that the input relay is blocked. This fault should not cause any immediate malfunctions. However, if the issue recurs upon restarting the unit, it is advisable to contact the support service center.
Why is my Riello UPS beeping continuously and showing codes F04, L04?
These codes indicate that the temperature of the dissipators inside the Riello UPS is too high. Ensure that the environment where the UPS is located is not exceeding 40°C.
Why is my Riello UPS beeping continuously and showing codes F53, L53?
These codes indicate a fault detected on one or more applications powered by the Riello UPS. Disconnect all the applications and then reconnect them one by one to identify the faulty application.
General| Power Range | 1-10 kVA |
|---|---|
| Output Power Factor | 0.9 |
| Expansion Slots | Yes |
| Rack/Tower Convertible | Yes |
| Topology | Online Double Conversion |
| Output Voltage | 230 V |
| Communication Ports | USB, RS232 |
| Battery Type | VRLA |
| Frequency Range | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Protection | Short circuit |
Essential safety guidelines and warnings for operating and maintaining the UPS.
Instructions for setting up the UPS and battery box in a vertical tower configuration.
Procedures for converting and installing the UPS and battery box into a standard rack cabinet.
Step-by-step guide for connecting the UPS unit to its battery extension box.
Guidelines for making electrical connections and wiring the UPS for operation.
Specific wiring instructions for 8-10kVA single-phase UPS models.
Detailed wiring procedures for three-phase UPS models.
Procedures for the first power-up and configuration of the UPS.
A guide to identifying and resolving typical UPS operational issues and errors.
Comprehensive list and explanation of UPS fault codes, alarms, and active controls.
To Next Page