25
2903104
Maintenance
9.3 Opening the burner
For accessing to the interior of the burner, loosen the screws that
secure the cover and proceed with the maintenance operation.
Check the operation
– Start-up of the burner with a sequence of functions (see
chapter “Burner start-up cycle” on page 22).
– Ignition device
– Flame monitoring
– Tightness test of components to the passage of fuel
Disconnect the electrical supply from the burner
by means of the main system switch.
Turn off the fuel interception tap.
Wait for the components in contact with heat
sources to cool down completely.
Operating safety hazards
Repairs to the following components may only be
carried out by the respective manufacturers or by
personnel instructed by them:
– fan motor
– electromagnetic valves
– burner programmer
To Next Page
Loading...
