20068428
46
Start-up, calibration and operation of the burner
The value 1 appears on the display screen:
After approx 8 seconds (it depends on the duration of the pro-
gramme), the
0 value appears on the display screen, this is to in-
dicate that the restore process has been completed correctly.
When the restore process is successfully completed, the 0
value is shown on the display screen.
Err C information: 136 D: 1 (restore process initialised) is
displayed for a brief moment.
At the end of the restore process, it is neces-
sary to check the sequence of functions and
the list of parameters.
To Next Page
Loading...
