21
3. If it is too hard to fully close the lever, open
the lever again and loosen the adjustment
nut at the opposite side a little bit by turn-
ing it counter clockwise.
4. If the quick release lever can easily be
pushed to the closed position, this means
the clamping force is insucient.
Open the lever again and tighten the ad-
justment nut at the opposite side a little bit
by turning it clockwise.
5. Never try to fasten a wheel
by rotating the quick release lever as shown
on the right. Detachment of the wheel as a
result of improper use of quick release can
result in serious injury. Always use the
adjustment nut on the other side.
5.2. SADDLE AND SEAT POST
Check whether the saddle and seat post are properly secured. Try to twist or move the saddle.
The saddle or seat post must not move. If your E-Bike is equipped with a seat post clamp with
quick release, you have to check whether the saddle is set to the correct height (see section 3.2.
on page 15).
WARNING
Adjustment
(Source: Shimano techdocs)
To Next Page
Loading...
