44
8.3.4. Chain
Make sure to clean and lubricate the chain at least every 300 miles. After riding in the rain, it
might be necessary to lubricate the chain more frequently. Purchase a suitable lubricant from
your authorized dealer.
Check the chain tension on E-Bikes with gear hubs. Try to move the chain up and down in the
center between the front and the rear sprockets. If the chain can be deflected by more than ¾“,
bring your E-Bike to your authorized dealer to retighten or replace the chain.
8.3.5. Belt drive
Perform an inspection of your belt for visible damage every 300 miles.
For more information refer to the separately included manual supplied by Gates.
8.3.6. Tires
Check the air pressure once a month using an air pump with gauge. You will find the minimum
and maximum pressure on the sidewall of the tires (see section 5.5 on page 22. The air pressure
in the tire must be greater than the minimum value and not exceed the maximum value.
Check the tires for wear, tear or damage and true running. A worn tire will provide less traction
on wet or dirty ground. It is also less puncture resistant. Only your authorized dealer may change
the tires.
E-Bikes from Riese&Müller are equipped with OEM tires that are highly puncture-proof.
8. MAINTENANCE AND REPAIRS
WARNING
Avoid accidents, falls and serious injuries.
Do not overinflate or underinflate your tires.
If the tire pressure is too low or too high, the tire may burst or detach from the rim.
For questions regarding the repair of a puncture, contact your authorized dealer.
To Next Page
Loading...
