Chapter 2 Front Panel Operations RIGOL
DG1000Z User’s Guide 2-113
The option installation procedures:
Edit the option installation file according to the above requirements
and store it into a USB storage device.
Turn on the instrument and insert the USB storage device. Press Store
to enter the store and recall interface.
Read the option installation file following the steps below in the store
and recall interface (refer to “Store and Recall”).
Select “D Disk” set the file type to “All” select the installation file
metioned above press Read.
2) Install the option by sending SCPI commands
Open the remote control window and send the following option installation
commands by referring to “Remote Control
”.
:LICense:SET <license>
or :LICense:INSTall <license>
Wherein, <license>
is the option license (note that the hyphens should be
omitted).
For example, :LICense:INSTall SM9KD3YPMWNP2AQMST8J5H592EQT.
If the option is successfully installed, the prompt message informing you that
the option installation succeeds will be displayed; otherwise, the corresponding
error message will be displayed.
To Next Page
Loading...
