Chapter 3 Remote Control RIGOL
DL3000 User’s Guide 3-9
Note: If you want to remove the resource, select the resource and then click
to remove it.
If the resource cannot be searched automatically:
Select the GPIB card address of the PC from the drop-down box of
"GPIB0::" and select the GPIB address set in the load from the drop-down
box of "0::INSTR".
Click
to check whether the GPIB communication works
normally; if not, please follow the corresponding prompt messages to
handle it.
5. View the device resource
The searched instrument resource will be under the directory of "RIGOL Online
Resource", as shown in the following figure.
6. Control the instrument remotely
Right-click the resource name "DL3031A (GPIB0::2::INSTR)", and select "SCPI
Panel Control" to open the remote command control panel, as shown in the
following figure. Then you can send commands and read data through the
panel.
To Next Page
Loading...
Need help?
General
