Rigol DL3000 User Manual

Chapter 1 Quick Start RIGOL
DL3000 User’s Guide 1-5
(3) CR key
Pressing this key can enter the constant resistance (CR) mode.
You can set parameters for the mode, such as resistance and
range.
(4) CP key
Pressing this key can enter the constant power (CP) mode. You
can set parameters for the mode, such as power and upper limit
of the voltage.
(5) Con key
Pressing this key can enter the continuous (Con) mode. You can
set parameters for the mode, such as range, Level A, Level B,
rising slew rate, and falling slew rate.
(6) Pul key
Pressing this key can enter the pulsed (Pul) mode. You can set
parameters for the mode, such as range, Level A, Level B, rising
slew rate, and falling slew rate.
(7) Tog key
Pressing this key can enter the toggled (Tog) mode. You can set
parameters for the mode, such as range, Level A, Level B, rising
slew rate, and falling slew rate.
(8) List key
Pressing this key can enter the list operation interface. You can
set parameters such as mode, range, the number of times the list
is cycled
, and the number of steps.
4. System Function Keys
(1) Local/remote switch key
In remote operation mode, when you press this key, you can
switch to the local mode.
(2) System utility function key
 System
Sets the system language, power-on value, brightness,
short-circuit function, digital input/output, beeper (on/off),
Sense function, log, Von Latch function, voltage monitoring
output terminal, and current monitoring output terminal.
 Interface
Configures parameters for remote communication interfaces
(GPIB/USB/RS232/LAN)
.

Rigol DL3000 Specifications

General

Brand	Rigol
Model	DL3000
Category	Measuring Instruments
Language	English