Rigol DM3058 - Page 166

RIGOL
Programming Guide for DM3058
5-50
ACI measurement.
Before sending the command, run the command ―[SENSe:]CURRent:AC:NULL
[:STATe]□ON‖ to enable NULL function.
Return Format:
The query returns the NULL value of ACI measurement.
4. [SENSe:]CURRent:AC:PEAK:STATe
Command Format:
[SENSe:]CURRent:AC:PEAK:STATe□{ON|OFF}
[SENSe:]CURRent:AC:PEAK:STATe?
Function:
The command sets or queries the enable state of ACI peak-to-peak measuring
function.
Explanations:
[SENSe:]CURRent:AC:PEAK:STATe □ {ON|OFF}: Enable or disable ACI
peak-to-peak measuring function.
[SENSe:]CURRent:AC:PEAK:STATe?: Query the enable state of ACI peak-to-peak
measuring function.
The command ―[SENSe:]CURRent:AC:NULL:VALue‖ can be used to set the ACI
peak-to-peak value.
Return Format:
The command returns the enable state of ACI peak-to-peak measuring function.
5. [SENSe:]CURRent:AC:RANGe:AUTO
Command Format:
[SENSe:]CURRent:AC:RANGe:AUTO□{ON|OFF}
[SENSe:]CURRent:AC:RANGe:AUTO?
Function:
The command sets or queries the enable state of ACI autorange function.